Plug Boot Puller
Spark plug boot puller?
I've got a broken off terminal inside a spark plug boot. I've seen pullers that pull a boot out of an engine block and/or off a plug but not one that pulls the boot off the wire. Does such a tool exist? I'd prefer to just replace a broken off terminal rather than to buy a whole new V8 plug wire set. Thanks in advance.
all you need is needle nose pliers. hold the boot with 1 hand and grab the end withe the pliers and pull.
 |
 Mercedes V6 Engine Spark Plug Boot Puller 17mm Wrench for Removing Installing  US $20.50
|
 Spark Plug Boot Puller Ratt Rod Car Truck Hot Rod US $13.50
|
 3 Pairs of SK and Matco Grabber Spark Plug Boot Puller US $35.00
|
 VW Audi Spark Plug Wire Boot Puller Remover US $17.50
|
 SLY 65350 Schley Products Universal Long Reach Spark Plug Boot Puller US $54.69
|
 SLY 98180A Schley Products VW Audi Spark Plug Boot Puller And Installer US $73.57
|
 KDT 2568 KD Tools Spark Plug Boot Puller US $15.08
|
 VW Audi Spark Plug Wire Boot Remover Puller Tool 20 16 Engine T10112 US $16.99
|
 WILMAR INSULATED SPARK PLUG BOOT PULLER W80532 US $3.39
|
 Kent Moore Spark Plug Boot Grommet Puller Remover 3800 Etc J 39294 NEW US $52.95
|
 AMPRO T71222 INSULATED SPARK PLUG BOOT PULLER US $3.39
|
 VW Spark Plug Boot Puller Tool Golf New Beetle Audi A3 US $39.95
|
 Lisle Spark Plug Boot Puller 51250 US $6.47
|
 KD Tools KDT2568 Spark Plug Boot Puller US $13.93
|
 SE TOOLS SPARK PLUG BOOT PULLER SES824N DISTRIBUTOR SAMPLE NEW UNOPENED US $8.24
|
 VW Audi etcSpark Plug Wire Boot Puller Remover US $16.99
|
 3050 SPARK PLUG BOOT PULLER US $11.89
|
 GearWrench KD 3 Piece GearPlier Spark Plug Boot Puller Tip Set KD 3834 US $12.00
|
 Schley 65350 LONG REACH SPARK PLUG BOOT PULLER PLIERS US $54.95
|
 KD SPARK PLUG BOOT PULLER 9514 US $1.49
|
 Kentmoore Spark Plug Boot Puller J43094 US $127.99
|
 Schley Products Long Reach Spark Plug Boot Puller Pliers 65350 US $34.99
|
 2 SPARK PLUG BOOT PULLER REMOVER NEW DIAGNOSTIC TOOL 2 US $12.99
|
 KENT MOORE J 39294 3800 SPARK PLUG BOOT PULLER SH556 US $49.49
|
 Kent Moore J 43094 Spark Plug Boot Puller for 35L Engine GM special tool US $41.24
|
 VW Golf Beetle Jetta 4 Spark Plug Wire Boot Puller Remover 20 engine Tool US $18.99
|
 New GearWrench KD 3 Piece GearPlier Spark Plug Boot Puller Tip Set KD 3834 US $21.95
|
 Spark Plug Boot Puller US $8.99
|
 MAC tools Grabbers 40° Bend Angle Offset Jaw Spark Plug Boot Puller Pliers NEW US $27.99
|
 Kent Moore J 36011 Spark Plug Boot Puller US $17.95
|
 VW Audi Spark Plug Boot Wire Puller Remover Installer 20 engine Tool US $16.99
|
 Alltrade 648423 Spark Plug Boot Puller US $13.71
|
 Kd Tools KDS2568 Spark Plug Boot Puller US $5.85
|
 Schley Products Inc 65350 Universal Long Reach Spark Plug Boot Puller US $41.68
|
 Schley VW Audi T Handle Spark Plug Boot Puller and Installer 18 20 turbo NEW US $39.99
|
 Performance Tool Insulated Spark Plug Boot Puller W80532 US $7.49
|
 Audi A3 A4 A5 A6 TT Spark Plug Wire Boot Puller Remover Tool 20 16 Engine US $18.99
|
 SK facom Spark Plug Boot Puller Tools Plier Grabber NEW US $22.90
|
 Universal Long Reach Spark Plug Boot Puller SCH65350 BRAND NEW US $48.84
|
 New T Handle Spark Plug Boot Puller US $9.99
|
 Universal Long Reach Spark Plug Boot Puller US $48.99
|
 Spark Plug Boot Puller 3050 US $5.95
|
 VW Audi AEG AVH AZG BBW BDC BEV Spark Plug Wire Boot Puller Remover Tool US $18.99
|
 Kent Moore J 43094 35L Engine SPARK PLUG BOOT PULLER US $59.95
|
 JEGS Performance Products 80574 Spark Plug Boot Puller US $9.89
|
 Mopar Performance P5249718 Plug Wire Boot Puller US $23.99
|
 Ripped Spark Plug Boot Puller auto car repair tool US $44.50
|
 Schley Products Ripped Spark Plug Boot Puller US $32.99
|
 SPARK PLUG BOOT PULLER US $4.68
|
 Spark Plug Wire Boot Puller Remover 20 engine US $16.99
|
 45DEGREE LONG SPARK PLUG BOOT PULLER PLIER US $16.24
|
 90 DEGREE SPARK PLUG BOOT PULLER PLIER US $20.03
|
 Spark Plug Wire Boot Puller Remover VW Audi etc US $16.99
|
 Sealey Spark Plug Boot Puller Tongs AK865 US $10.76
|
 SEALEY TOOLS SPARK PLUG PULLER BOOT TONG PLIER US $5.06
|
Have your car dents repaired at a fraction of the cost!
The most inexpensive answer to auto body repairs is Paintless dent repair...and these repairs can be done by you with just a little bit of direction.
Not only is body shop work very expensive, it is also quite inconsistent, especially with tough colors to match like white, silver, and black.
Paintless dent repair can be done with the magic of just 4 things: (1) Tools (and they don't have to be professional tools!); (2) A good light; (3) Patience; (4) An eye for detail.
The first thing to do is gather your light and place it against the vehicle, pointing towards you with the dent between the light and you.
The second thing is to ready your tool of choice that is long enough and angled enough to reach the dent be able to strongly press against it.
The third thing is to find the access point to enter the cavity of the body panel. The doors can be accessed by easily pulling the rubber boot from any door plug hole (in the door jam of the door), while allowing the wiring to remain as it is (the rubber boot is used as a wire protector and can easily be replaced back to its normal position when you're done).
Now it's time to begin!
Make certain you have a well-taped end to your chosen tool so as not to cause un-wanted panel dimples. Insert the tool through the door plug hole until you reach the dent with the tip of the tool (you will be able to see the tool by looking down the panel where the light is shining over the dent at you - this is where you will keep your eye view!).
SPECIAL NOTE: You can't press too softy, but you can press too hard...so be gentle.
Once you find the dent spot with the tool, move the tool in a circle around the dent into you "feel" the tool reach the center of the dent.
Begin to press outward on the dent and then back off. Press outward again and back off...continue this rhythmic motion until the dent disappears.
Depending on the size of the dent, it will take anywhere from 15 gentle presses up to 100 presses (for really big dents!).
Once the dent has been flattened, you may see very faint "high spots" from where you were pressing.
That's normal.
Now, take a tap hammer (or light hammering instrument) and plastic rod with a point (like a pointed plastic chisel) and make light taps to flatten the "high spots".
SPECIAL NOTE: The metal wants to go back to where it started. It's called, "Metal Memory". As you bend and tap, the metal will gladly follow your lead as long as you're gentle.
Your finished!
For more information, please contact Alex Zaborowski at 877-336-8299 or visit his website at www.dentsaway.net
About the Author
Tom Vann is an author, trainer, dealership owner, and marketer in the automotive industry. Tom is best known as the creator and trainer of the most electrifying and revolutionary car sales training methodology in the industry...known as Velocity Selling methodology (at
www.tomvann.com
).
Tom became acquainted with Alex Zaborowski in 2007 when ZAB (as he is known) was a "Special Finance Manager" and trainer of dealership finance departments throughout the midwest.
ZAB began his Paintless Dent Repair Business in 2009 and quickly became one of the most well-respected professionals in his field throughout the upper midwest.
